100mm Marine Wet Exhaust Hose

RMWE100 is supplied cut, in 1 m, 3 m, 5 m, 8 m, 10 m, 12 m, 15 m and 20 m lengths, which matters at 100 mm bore because an exhaust run this size is heavy and awkward to join. One continuous length from muffler to transom removes a joint, and every joint removed is one less clamp to inspect. The hose is the same construction as the rest of the range: exhaust-gas resistant tube, synthetic cord and steel wire helix, corrugated ozone and oil resistant cover.

Key features

• 100 mm inside diameter
• Eight cut lengths: 1 m, 3 m, 5 m, 8 m, 10 m, 12 m, 15 m, 20 m
• Steel wire helix inside high-strength synthetic cord
• Smooth bore tube resistant to exhaust gases
• Black corrugated cover, resistant to ozone and oil
• 3 bar (43.5 psi) working pressure
• -30 to +100°C temperature range
• MCG, DNV, LLOYDS and VTT marine approvals

Applications

• Main engine exhaust on larger inboards
• Commercial and charter vessel exhaust systems
• Long transom runs made in one piece
• Wet exhaust discharge carrying gas and raw water

Compatibility and fitting

• Measure the whole route, including the slack for bends, before choosing a cut length
• Heavy duty stainless clamps suit this bore: see the hose clamp range
• Hull and transom outlets are in skin fittings and marine products
• 125 mm, 150 mm and 200 mm are in the marine exhaust hose range

Can I join two shorter lengths instead?

You can, but each join needs a proper connector and four clamps, and it becomes another place to inspect at survey. On a 100 mm run it is usually cheaper and safer to order the next length up and trim it.

Dispatched from our Brisbane warehouse. Australia-wide delivery, or collect from the warehouse once your order is confirmed ready.