150mm Marine Wet Exhaust Hose

Heavy commercial exhaust runs are where 150 mm hose belongs, and the deciding question at this size is always the spigot. RMWE150 has a 150 mm inside diameter and it is not going to stretch: the flange or spigot it slides onto has to be the matching size, and the hose has to be pushed fully home so both clamp bands sit on metal. Construction is the same proven wall used across the range, with a steel wire helix in high-strength synthetic cord.

Key features

• 150 mm inside diameter
• Steel wire helix within high-strength synthetic cord reinforcement
• Smooth tube, resistant to exhaust gases
• Black corrugated cover, resistant to ozone and oil
• Working pressure 3 bar (43.5 psi)
• Temperature range -30 to +100°C
• Approved by Nordic boat standard MCG, DNV, LLOYDS and VTT
• Cut in 1 m, 3 m, 5 m, 8 m, 10 m, 12 m, 15 m and 20 m

Applications

• Heavy commercial exhaust systems
• Workboat and fishing vessel main engines
• Large water lift muffler outlets
• Exhaust and raw water mixture discharge at 150 mm

Compatibility and fitting

• Match the 150 mm bore to the exhaust spigot exactly; no oversize hose and packing
• Warm the hose end before fitting so it slides fully onto the spigot
• Heavy duty stainless bands are in the clamp range
• Through-hull and transom fittings are in skin fittings and marine products
• Other bores are in the marine wet exhaust hose collection

Will a 150 mm hose stretch onto a larger spigot?

Rubber takes a small amount of interference, but do not rely on it at this diameter. Measure the spigot and order the bore that matches, because a hose stretched to fit will not seat far enough for both clamp bands to land on metal.

Dispatched from our Brisbane warehouse. Australia-wide delivery, or collect from the warehouse once your order is confirmed ready.