200mm Marine Wet Exhaust Hose

RMWE200 is the largest bore stocked in this wet exhaust range, at 200 mm inside diameter, and it is a two-person hose to handle before it is ever a two-person hose to fit. The construction does not change with size: a smooth tube resistant to exhaust gases, high-strength synthetic cord reinforcement carrying a steel wire helix, and a corrugated black cover that resists ozone and oil in a commercial engine room.

Key features

• 200 mm bore, the largest in the range
• Reinforced with high-strength synthetic cord over a steel wire helix
• Smooth exhaust-gas resistant tube
• Ozone and oil resistant corrugated cover
• 3 bar (43.5 psi) working pressure
• Service range -30 to +100°C
• MCG, DNV, LLOYDS and VTT approvals
• Cut from 1 m up to 20 m

Applications

• Heavy commercial and workboat exhaust runs
• Large main engine wet exhaust systems
• Silencer and muffler outlet connections at 200 mm
• Combined gas and cooling water discharge lines

Compatibility and fitting

• Plan the route and the lifting before cutting: a 200 mm length is not repositioned easily once clamped
• Support the full weight of the run on brackets, not on the exhaust spigot
• Large stainless clamps to suit are in the hose clamp range
• Smaller bores from 25 mm upward are in marine wet exhaust hose

Is 200 mm the biggest size available?

It is the largest bore in this range, and it sits above 150 mm and 125 mm which cover most commercial engines. For anything beyond it the exhaust is normally built in rigid pipe with a short flexible section.

Dispatched from our Brisbane warehouse. Australia-wide delivery, or collect from the warehouse once your order is confirmed ready.