32mm Marine Wet Exhaust Hose

What separates 32 mm wet exhaust hose from a rubber hose of the same bore is the paperwork behind it. RMWE032 carries approvals from Nordic boat standard MCG, DNV, LLOYDS and VTT, which is what a surveyor looks for on an auxiliary or genset run, and it is constructed for the job: synthetic cord reinforcement wound with a steel wire helix, an exhaust-gas resistant tube inside, and a corrugated cover formulated against ozone and oil outside.

Key features

• Approved by Nordic boat standard MCG, DNV, LLOYDS and VTT
• 32 mm bore
• Reinforced with high-strength synthetic cord and a steel wire helix
• Tube is smooth and resists exhaust gases
• Corrugated black cover, ozone and oil resistant
• Pressure rating of 3 bar (43.5 psi)
• Rated from -30 to +100°C
• Supplied in eight cut lengths, 1 m through to 20 m

Applications

• Auxiliary engine and genset exhaust runs
• Small inboard exhaust where survey approval is required
• Water lift muffler to transom on a compact installation
• Raw water discharge carrying a gas and water mixture

Compatibility and fitting

• Match the hose bore to the exhaust spigot and keep the same size the whole way
• Stainless worm drive clamps hold each joint: see the hose clamp range
• Stainless threaded fittings for the raw water side are in stainless steel fittings
• Other bores from 25 mm to 200 mm sit in the wet exhaust hose collection

What do the MCG, DNV, LLOYDS and VTT approvals cover?

They are the marine approvals the manufacturer holds for this hose, and they are the reason it can be specified on a survey job rather than a general purpose rubber hose. Ask for them by name when a surveyor queries an exhaust replacement.

Dispatched from our Brisbane warehouse. Australia-wide delivery, or collect from the warehouse once your order is confirmed ready.