38mm PVC Oil Suction Hose Blue

This is the 38 mm bore blue oil suction hose, stock code PSHB040, used on waste oil collection trucks and transfer pumps where a 32 mm line runs out of flow. Outside diameter is 46.1 mm. It is the same extremely flexible high nitrile PVC as the rest of the range with a rigid PVC helix through the wall, so it stays open on a pump inlet and still coils tightly enough to stow on a truck. Working pressure is 0.7 MPa (101 psi) at 20°C.

Key features

• 38 mm inside diameter, 46.1 mm outside diameter
• Blue PVC wall with a rigid PVC helix
• High nitrile content for mineral oil resistance
• Working pressure 0.7 MPa (101 psi) at 20°C
• Operating temperature -5°C to +60°C
• Cut lengths 2 m to 15 m, or a 20 m coil

Applications

• Waste oil collection vehicles
• Bulk oil transfer between drums and tanks
• Environmental spill and waste recovery
• Septic tank pump-out lines
• Chemical collection on industrial sites

Compatibility and fitting

• Clamp 38 mm tails or camlocks over the helix; see camlock fittings
• Keep suction runs short and the lift low, since every metre of hose costs the pump prime
• For petrol and diesel duty step across to rubber petrol and oil suction hose

Does it suit diesel and petrol?

The supplier lists mineral oils, chemicals and some fuels, which is not a blanket approval. For a dedicated fuel line, use a hose specifically rated for the fuel rather than relying on the general listing here.

Dispatched from our Brisbane warehouse. Australia-wide delivery, or collect from the warehouse once your order is confirmed ready.