Rubber Fuel Filler Hose Elbows

These are moulded fuel filler elbows for the short, awkward run between a filler neck and a tank, where a straight hose would kink and hold fuel. They meet SAE 30R6 and are non-wire reinforced, with a petroleum-resistant nitrile tube, tough textile cord reinforcement and a smooth oil resistant cover. Working pressure is 20 PSI, which is the point to understand: this is a fill and vent hose, not a pressurised fuel feed. Temperature rating is -40°C to +100°C, and -40°C to +51°C on bio-diesel B20.

Key features

• Bores of 38 mm (1 1/2"), 50 mm (2") and 57 mm (2 1/4")
• Available as 90 degree and 45 degree elbows in each size
• Meets SAE 30R6 specifications
• Petroleum-resistant nitrile tube, textile cord reinforcement, oil resistant cover
• Non-wire reinforced
• Working pressure 20 PSI
• Temperature rating -40°C to +100°C, and -40°C to +51°C on bio-diesel B20
• Suits gasoline, gasohol blends of ethanol and methanol, ethers, diesel and bio-diesel to B20

Applications

• Auxiliary fuel tanks on recreational vehicles
• Filler neck to tank runs on passenger cars and trucks
• Long range tank installations on four-wheel drives
• Diesel and bio-diesel filler plumbing
• Replacing a perished original filler hose

Compatibility and fitting

• Clamp both legs with fuel-rated clamps; see hose clamps
• Because it is non-wire reinforced, support the elbow rather than letting the tank hang on it
• Straight filler and barrier fuel hose is on USCG approved fuel filler hose

Can it be used on the fuel feed line?

No. At 20 PSI working pressure this is a filler and vent hose. A pressurised feed from a pump needs a hose rated for that pressure and for continuous fuel contact.

What does B20 mean for the rating?

Bio-diesel is harder on the tube. The hose is rated to bio-diesel blends up to B20, and on B20 the temperature ceiling drops from +100°C to +51°C.

Dispatched from our Brisbane warehouse. Australia-wide delivery, or collect from the warehouse once your order is confirmed ready.